Garmin is aware of this due to beta test reports, but I was curious to know if anyone else noticed the floor counter is giving credit for about 6 foot increments rather than 10 feet? I am in a hilly area, and have been scaling the Empire State Building daily according to my F5. Really I am not, but 110 floors is a bit much. Otherwise the elevation meter has been working very nicely with a faster response time than it used to, and hopefully that doesn't revert to fix the floor counter.
I am on FW 12 but my sensor is 6.20! Anyone else can check this please?
I too am still on sensor hub 6.20 I have not installed any betas along the way so I believe the only recent sensor hub updates came inside the beta dls
So it looks that either Garmin forgot to include it in the stable version or, they decided not too... It would be fair to receive an answer from them which is which...
On last Beta sensor hub was V6. 23....This morning the F5 told my new Version 12.0 installed... I check the sensor hub and it shows 6.25...So i think the sensor roll out with this update.....
On last Beta sensor hub was V6. 23....This morning the F5 told my new Version 12.0 installed... I check the sensor hub and it shows 6.25...So i think the sensor roll out with this update.....
6.25 was from your last beta I believe. I am still on 6.20 even though I have fw 12.0. No betas on my end. Curious why 6.25 was not included in this fw uppate.
hansap, could you please tell me where I can find just the 6.25 firmware?
I still had it on my PC from the time I downloaded the 11.58 beta, but then again the link to the 11.58 beta is still at the top of the forum. You can download the 6.25 sensor hub from there. You only need to copy the sensor hub to the Fenix once you have downloaded and unzipped. It will install by itself, at least it did for me.
