Fenix 5X and FE-C

Former Member over 8 years ago

I can't get the right speed from my Elite Real Emotion B+

My Edge 1000 detects the roller as ANT+ FE-C with speed sensor. And although the speed reading is not accurate, it is kind of normal.

The Fenix 5X detects the speed sensor on the roller as an speed/cadence sensor. But no matter what wheel size I set up, the speed shown on the watch is ridiculously high (even more than 1000 Km/h :confused:). I had to disable it.

0 Iron_Cinghi over 8 years ago

I can't get the right speed from my Elite Real Emotion B+

My Edge 1000 detects the roller as ANT+ FE-C with speed sensor. And although the speed reading is not accurate, it is kind of normal.

The Fenix 5X detects the speed sensor on the roller as an speed/cadence sensor. But no matter what wheel size I set up, the speed shown on the watch is ridiculously high (even more than 1000 Km/h :confused:). I had to disable it.

Which size did you entered? I have drivo and I must put 611mm

0 Iron_Cinghi over 8 years ago

I can't get the right speed from my Elite Real Emotion B+

My Edge 1000 detects the roller as ANT+ FE-C with speed sensor. And although the speed reading is not accurate, it is kind of normal.

The Fenix 5X detects the speed sensor on the roller as an speed/cadence sensor. But no matter what wheel size I set up, the speed shown on the watch is ridiculously high (even more than 1000 Km/h :confused:). I had to disable it.

Which size did you enter?

0 Former Member over 8 years ago

Which size did you entered? I have drivo and I must put 611mm

Yes, it was the wheel size finally. I had to set it to 267mm. I was trying with "real life" wheel sizes.

Curiously enough, the same roller on the Edge 1000 is detected as FE-C and didn't need this wheel size setting. But the Fenix is unable to detect the ANT+ speed sensor on the roller.

Thanks.

0 Iron_Cinghi over 8 years ago

Yes, it was the wheel size finally. I had to set it to 267mm. I was trying with "real life" wheel sizes.

Curiously enough, the same roller on the Edge 1000 is detected as FE-C and didn't need this wheel size setting. But the Fenix is unable to detect the ANT+ speed sensor on the roller.

Thanks.

if you use the trainer ad powermeter and speed/cadence on the edge1000, you must set the wheelsize