This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

software version 11.0

looking at the change log for fw 11.0 i can't see an item mentioning GPS v2.60 despite this being in one of the earlier public betas (10.71). has the new gps version been pulled or forgotten to mention?

Top Replies

JeyJey over 5 years ago in reply to TomaekThompson +1 suggested

I rebooted my mobile phone and the GPS update was available via OTA
parentoft over 5 years ago in reply to Culex42 +1

10.XX cannot run on GPS 2.60 - so it is on purpose that it has to be done like this.
rugby4all over 5 years ago +1

Updated to 11.00 from 10.10 over WiFi and could see GPS version 2.50! like most of you... Could not seem to get the GPS to upgrade using either WiFi or Garmin Connect. Decided connect the watch to the…

All Replies

0 Dr Phil over 5 years ago

What GPS version do you have? It might have crept in.

0 parentoft over 5 years ago

You probably have to Syncronize twice.. First to get 11.00 - and secondly to get GPS 2.60 (Stated earlier that version below 10.70 cannot install a GPS 2.60 and as therefore you have do sync. twice).

0 parentoft over 5 years ago

Did it work?? What I did was I got the FW 11 OTA.. installed int, turned the watch off, Turned it on and then syncronized again and the GPS 2.60 was ready to download.

0 JeyJey over 5 years ago in reply to parentoft

I do the same and my version is still a 2,50 with a exclamation mark besides it

0 Sam201176 over 5 years ago

I always use WiFi to upgrade public release software now.. because of the GPS ... and the GPS version is always updated the first time... no need to sync twice using WiFi.....at least for me.

0 TomaekThompson over 5 years ago

I too have v2.50 with exclamation mark. restart or connecting to garmin express doesn't change anything

0 parentoft over 5 years ago in reply to TomaekThompson

Turn off the watch... Wait 2 mins turn it on again... then sync using a computer and you should get the new firmware.

+1 JeyJey over 5 years ago in reply to TomaekThompson

I rebooted my mobile phone and the GPS update was available via OTA

0 Culex42 over 5 years ago

Similar situation for me, SW 11 installed, but GPS stayed 2.50(!). I have plugged in to PC, run Express. The bubble icon on the device showed number 4 but there were only 3 map updates (other regions). Nothing else. When I have disconnected the watch it has offered to install the GPS module and has done it.

0 parentoft over 5 years ago in reply to Culex42

10.XX cannot run on GPS 2.60 - so it is on purpose that it has to be done like this.