This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

7.6 Will Not Connect To Sensors

Fenix 5X Plus on 7.60 SW.

First my Tri HRM would not connect to my warch, than I noticed the next day my cadence and speed sensors were not connecting either. I had to hold light key to hard reset than all three connected immediately. Unfortunately this was after my hour long training session so my hrm data was garbage because the PPG doesn't work at all mountain biking.

0 Former Member over 6 years ago

Same problem, which started about two weeks ago. I even updated FW to Beta 8.02, but it did not solve the problem. My sensors still connect to my Garmin 810.

0 Sim over 6 years ago

Me too lost my HR sensor. Had to delete and reconnect. 1st time it happened. FW 7.60. 5Plus.

0 NwtnsMthd over 6 years ago

Happened to me last night. The following process fixed the issue, I'm not sure if all of the steps are necessary.

Deleted HRM TRI from paired sensors.
Rebooted watch (crashed on reboot), forced reboot by holding LIGHT button for 30 seconds.
Paired HRM TRI.

I have a Fenix 5X Plus with FW 7.60