Enduro - 20.42 Public Beta

Hello Enduro customers,

Our next beta version for the Enduro is now available!

Please download from the following link:

Enduro - www8.garmin.com/.../download_details.jsp

Instructions for installation are available below the change log after clicking the link above.

This update does bring in a modification to the software update process: If you load 20.42 to your device, disconnect, and choose to install later, it will delay the installation 2 hours and you will then get a prompt and a 30 second countdown. This process is only available if you are updating from 20.41 to 20.42.

20.42 Change Log Notes:

Improved robustness to nightly altitude calibration.
Fixed altitude flatline bug.
Fixed potential issue on device boot.

Current beta peripheral software version numbers below. New versions are indicated in red.

GPS: 5.30
Sensor Hub: 11.01
ANT/BLE: 3.00

Please note, the beta updates released on these forums are not compatible with APAC region devices.

Please send all bug reports to [email protected], and indicate which model of the Fenix 6 Series you have in the subject line.

0 3vdo over 2 years ago

Thanks! One test run done, and elevation recorded seem to be good.

0 Steve_A_2 over 2 years ago

I'm sure this has been asked before, but why and how are your public betas always "not compatible with APAC region devices"????

0 4241327 over 2 years ago in reply to Steve_A_2

As far as I understand it, the APAC versions use up so much additional memory for the Asian fonts that they made a split there. They seem to have unified this from Fenix 7 onwards, but the Enduro came out before that.