Related

CT10 on putter

Eighty3
10 months ago

Need assistance in securing the CT10 to my putter,

Using the odyssey Rossie. The CT10 does not screw in fully. Does anyone have experience in this, if yes, how do you fasten it. 

Had a bad experience previously on not securing the CT10 to a previous putter. Short story: the screw part of the CT10 stuck permanently in the shaft while the electronic bit at the bottom of the golf bag Disappointed

  • 0 10 months ago

    Depending on the grip type used, the breath hole end of the grip will vary. The screws on the CT-10 sensors are a set standard size, so prior to using them users should ensure the fit into the grip is secure. 

    There is no official recommendation on additional items to use to help secure the grip per the type being used, but some users have had luck with plumbers tape around the threading of the sensor to secure into larger breathe holes.