I am using a 910xt and trying to set up a power based interval session
When I setup a power based interval workout on Garmin Connect I can specify a range - say 3 mins at 220 to 280. I transfer this to my 910 and when I start the interval the watch beeps at me throughout the interval as my power fluctuates outside the set range. This is because the power reading on the interval is being measured at 1 sec and not averaged over the entire interval
Contrast this with a run interval
A pace based run interval - say 3 min at 5:00 min/km to 5:20 min/km is averaged over the total 3 mins. My watch show the average pace record over the 3 mins, whereas my watch displays instant power over the interval
So -
Am I setting things up wrong?
Can I change the power setting so I get an average over interval reading?
Or am I stuck with this?
Thanks
(PS Posted on 910 thread as well)