This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Nasty Error Viewing Activity Detail

Former Member over 11 years ago

After uploading a bike ride, Garmin Connect dies on it, and I cannot even git to ANY activities (without deleting the bad one). I can, however load into Training Peaks and Strava, and view, with no issues.

The error I get is: "Can't create a measurement with NaN value.18 - percentage 17 - difference"

The file is attached. Though not sure it is file related.

Thanks in advance!

Greg

0 Former Member over 11 years ago

The error I get is: "Can't create a measurement with NaN value.18 - percentage 17 - difference"

OK, finally figured it out myself. Did a little more Googling/digging, and found that this error occurs when you enter a Power zone with an entry of 0 watts on the low end of Zone 1. Common Garmin, this has been out there a long time. Inhibit the entry of a zero!!

0 REKLATS2 over 11 years ago

Thanks for replying with the answer, I had the same problem. Updating my power zones so I didn't have a 0 (had been setting via %) fixed it.