This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Garmin Connect elevation correction is not working

Former Member over 11 years ago

Today, the elevation information comes up "disabled", as it should (note: for the past week or so, this was not the case; it opened in enabled mode). When I click on enabled, nothing happens.

0 SUSSAMB over 11 years ago

OK I think you've made the point, please don't multi-post again.

0 Former Member over 11 years ago

Sure is taking some time to get this fixed. Just noticed this on my Edge 500.

0 Former Member over 11 years ago

Same here. Does anyone at Garmin care about Connect working properly?

0 WARDBRADY over 11 years ago

elevation correct is still buggy, defaulting to disabled on a device with no barometric altimeter.... when I click enable... the obviously goofy elevation totals still remain.....

0 Former Member over 11 years ago

Come on Garmin get this software issue sorted out, it's really annoying.

0 fabulousevily over 11 years ago

I am having this issue too. Very annoying. It used to work just fine, so why did it change???

0 WARDBRADY over 11 years ago

the problem seems to change from day to day, defaulting to the incorrect enabled/disabled, sometimes it allows you to change from enabled to disabled but the data remains the exact same

I ran a flat 10 miler... I mean flat, and it came back with almost 600 feet of elevation gain.... I've run the same roads on other days and get less than 100 feet of elevation gain with corrections enabled