This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Elevation correction stopped working after Feb 19 new web page update FR310XT

The run I uploaded yesterday just before the web site and Garmin Express update had Elevation Correction enabled. The run I uploaded today has it disabled. I'm using Forerunner 310XT with latest firmware.

Also I can not toggle the setting on any of my previously uploaded runs. I have not changed any settings. What gives?:confused:

0 Dugiflopper over 11 years ago

Last time I tried it a few days ago, it's just the button highlighting wasn't changing to show you what is displayed. However clicking whichever button is clickable did refresh the data for that setting.

0 Former Member over 11 years ago

I've tried to disable the elevation corrections but I couldn't. Does anyone have the same problem? Please tell me if there's a solution to fix it.

I'm using Garmin Edge 500 Taiwan 3.10.0.0.

0 Former Member over 11 years ago

I have the same problem as of yesterday. Elevation corrections are enabled by default. I am using the edge 510 and whilst it has a barometric elevation data on the device, the garmin connect site only shows the correction data and you cannot change this like before. Is there a solution to this problem??

0 Former Member over 11 years ago

I have the same problem. I use (unfortunately) an 810 (I will never buy another one), I normally use the elevation with the corrections mode disabled however I have noticed that it is stuck to 'Elevation corrections; enabled'. It will not turn off.

I have had to change my 810, 3 times to to the elevation data being too far out to use, maybe Garmin cannot be bothered to fix the unit so instead just give the first impression that it's fixed by doing this and hoping that no one will notice?

0 XRT_Phil over 11 years ago

The run I uploaded yesterday just before the web site and Garmin Express update had Elevation Correction enabled. The run I uploaded today has it disabled. I'm using Forerunner 310XT with latest firmware.

Also I can not toggle the setting on any of my previously uploaded runs. I have not changed any settings. What gives?:confused:

I have exactly the same device and same problem. Elevation correction is disabled. I click enable, but nothing happens.
Here's an activity where I did several hill repeats in a gulley between 25 and 40 minutes from the start. It about 150 metres wide with about 20 metres vertical difference from the top to the bottom.
http://connect.garmin.com/activity/449357537

Phil