This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sending Workouts to device...

Former Member over 11 years ago

I've setup a workout and am trying to send it to my Edge 500.

Garmin Connect finds the device, but once I select it, I just get Preparing Workout with a status bar which doesn't fill.

Tried this a few times now over the last couple of days with no success.

Any ideas?

thanks in advance...

0 Former Member over 11 years ago

I'm having exactly the same problem sending to my edge 800.
Is it my PC?
any comments greatly appreciated.

0 TOMMO75 over 11 years ago

Yep same here on my 620, very frustrating. After a couple of seconds I get an error on page message at the bottom of the screen and then that's it hung. Strangely though it's hit and miss (more miss), this morning I managed to download 2 workouts but then I started getting this error again. When I tried before around the 20th Dec, I managed one download before the error started.

Could this be a browser issue? I'm using Internet Explorer on my PC.

Thanks

0 TOMMO75 over 11 years ago

This may well be browser related. I have just tried it again through Chrome and it seems to work fine. Have just downloaded 4 workouts onto my 620 straight off the bat no issues. Previously I was using IE 8.0.7601.17514.

I did have to install the Garmin connector plugin for Chrome from within the Chrome browser as this seems to be a browser specific application, it couldn't detect the IE installation already on my PC.

0 Former Member over 11 years ago

Been having the same issues with my new 910XT just now. Renamed the workout a couple of times and then it magically worked. Currently using IE 11, but will try some other browsers later and see if that helps get some consistency