This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Newbie problem

Former Member over 15 years ago

I went for a run while TDY and didn't have a computer. I went for another run and thought I was good to go and thought that the watch would know that this was a separate run. I bought a laptop and tried to load up my two runs but when I did get my computer setup it loaded my two runs as one run with two laps. Is there a way to separate the two runs into individual runs? I would appreciate it if someone could point me in the right direction.

"Pain is weakness leaving the body"

0 DW152 over 15 years ago

You didn't say which Garmin device you have, but when you finish a run, this is the normal sequence of things you should do:

- stop the timers by pressing the start/stop button
- then press and hold the lap/reset while it counts down 3-2-1 this resets the timers and stores the activity into the device's memory

If you don't do the last step, the device will think that you just paused the timer until you go on your next run.