Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Intensity minutes

Rafael16
over 7 years ago
Hello
My training week is shared between running, outdoor roadbike and indoor cycling. When using my roller I'm not able to use my Fenix 3HR because it interferes with the Elite's MyEtraining program that controls the roller (that application register the heart rate, cadence, speed and watts during the training session and also changes the load of the roller according to the program I am following). This situation forces me to enter the information recorded by the Elite's app into Garmin Connect manually. Everything goes as planned, but the register of intensity minutes is not updated. Doing 60 minutes of indoor biking with different wattage activates my heart as much as running does so it is not a problem of heart rate zones issue here.

Intensity minutes only uses the information coming from my Fenix 3hr or it is able to synchronize with Garmin Connect an update it's information?

Any advise to have my manual activities being registered in the Intensity Minutes register?

Best Regards

Rafael

  • 0 over 7 years ago
    Intensity minutes have to be registered by a garmin device. That said, you don't have to start an activity on your F3 to register intensity minutes. It's enough if you wear it with optical HR on.
  • 0 over 7 years ago
    Rafael16 what is it that you do on the Fenix that interferes? Is it ant+ connection to hrm or what? because it seems that just using optical hrm and starting an activity shouldn't conflict?
  • 0 over 7 years ago
    Rafael16 what is it that you do on the Fenix that interferes? Is it ant+ connection to hrm or what? because it seems that just using optical hrm and starting an activity shouldn't conflict?



    It is possible to use both at the same time, it's me that I have not dedicated enough time to setup different protocols to each one. I had that configuration about a month ago, but due to a reconnection I setup both in ant+ and this is a problem. Using bluetooth in the F3HR and ant+ in the Elite roller works fine.

    Regards

    rafael