Pre-created strength training alters the weight lifted by subtracting .5 pounds frequently and I have to fix it after every set

Hello! For the last several months my Fenix 7 subtracts .5 pounds from many of the strength weights I prepopulate, as well as leaves the last lifted weight in there when I start a predetermined body weight exercise. Is there a way to fix this so I don't have to manually bump every set back up to what I had it set at in the watch for the workout? For instance, if I set a weight that I will lift as 20 pounds, it shows 19.5 when I'm done and I have to bump it back up to 20. I would love to not have to do this. I've created different workouts, and sadly they all do this. This started in the fall, I believe.

Thank you!

Top Replies

seilogramp 4 months ago +1

I reported this to Garmin Support in September 2024. There is a discussion here - 18.14 Firmware - Weight Lifting Bug - Enduro 2 - Wearables - Garmin Forums

I created a test workout that had 5 lb. increments…

All Replies

0 seilogramp 4 months ago

I reported this to Garmin Support in September 2024. There is a discussion here - 18.14 Firmware - Weight Lifting Bug - Enduro 2 - Wearables - Garmin Forums

I created a test workout that had 5 lb. increments. Here are the weights from 5 to 230 lbs. that I found erroneous on my watch. All of these are reduced by .5, requiring editing on the watch or later in Garmin Connect:

5, 10, 20, 25, 35, 40, 55, 70, 75, 90, 95, 105, 110, 125, 140, 145, 160, 165, 175, 180, 195, 230.

0 Triasand 4 months ago in reply to seilogramp

Thank you! I searched and somehow missed that post. I greatly appreciate you sharing all of this information, and your post!