Hello
Yesterday I tried BaseCamp 3.2.2 with my Quest. I let is sync for a while. I created a rote and try to sent is to the Quest, but had some serious issues:
1) the route was short and it took for more than 30 seconds before it seemed that copying was ready.
2) I found a message on the Quest screen warming for an IO error, After that nothing possible anymore, I switched the Garmin off, but could not get is on anymore. I had to perform a Master Reset!
I have some questions:
1) is this common?
2) Why is it so slow in copying, MapSource only needs about 2 seconds!
gr Wim
Netherlands