VIRB edit export fails at 100%

Former Member over 11 years ago

Good evening,

i have the following problem:

Whenever I do a new project, I can only export the first few times.
I import some films from the VIRB and cut them, export them, everything is fine.
A second time may also work but at least at the third or forth time the export stops at 100% or at 99.99%.

That is bad because I need to send some videos to Garmin...
I already tried out all the tipps i read in this forum, but nothing worked. But I also havent read about this 100% problem.
Any advices?

Thank you for reading!

regards,
Valentin

0 Former Member over 11 years ago

I have the exact same problem, almost all the videos i try to export fails at 100%. The simply stay at 100% for hours, but never finish. I let one stay all night at 100% but nothing else happens.

i don´t know what to do, no trick works. And sincerely, tha camera it is ok, but it is very frustrating when you try to edit the video or show it to your friends for hours whithout success .... please improve the garmin edit now!!!!!!

regards

Pablo

0 Former Member over 11 years ago

Did you try the 2.6 Beta yet?

0 Former Member over 11 years ago

i had this and it was because my partition on my hard drive was full. i moved finished movies out of the program file> garmin ...wherever the video is and it was fine afterwards.

0 Former Member over 11 years ago

I have a little bit similar problem. I have done some videos with virb edit, and at the beginning it worked quite well. Then it started to stop hole program. I got to make videos in several peaces, but when it's ready to load or save it to the computer, it stops, and shut down hole program.

I thought that the problem was in my computer, but it is the same on the other computer. I even empty my computer and loaded virb edit again. It worked for couple videos okey. But now it is the same "stopping" all the time. So editing is ready, but I can't get to load or save it.

And I have a lot of room in my computer.