I do not know if this is the right place but I have some suggestions for the next version of virb edit with regard to the G-matrix data.
Is it possible to adjust the pressure setting? Right now you can only have the actual pressure or tell the program when the relative height was zero. As a pilot I regularly take-off from airfields above sea level and do not cross a point where the system is resetable to zero. I would like to adjust the pressure at the start so the altimeter matches the pressure reading.
Furthermore I was wondering if it is possible to modify the pitch and roll measurements by assigning a horizon and vertical reference since the camera is not always perfectly mounted.
Hope this is not too difficult.
Regards,
Freek