This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Quark power meter reading freezes after update to 4.0

2 rides same story, reading stops after few minutes. It's random value, yesterday I averaged 304wats over 3h. My unit is useless...everything else works fine so it's due to ble connection with power meter.

0 aweatherall over 6 years ago

I suspect that you are connected to the power meter over BLE and not ANT.

You can either try disabling the BLE senor pairing and re-pair over ANT or you can install the 4.36 beta release that fixes the BLE sensor issue.

0 pelich29er over 6 years ago

I installed 4.36 and works fine with ANT+ . On 4.0 I could only connect with BLE. I was not aware that I can choose between BLE and ANT. i did search in 1030 (add/sensor/power)and only BLE power meter poped up, not ant.

0 aweatherall over 6 years ago

Often the BLE protocol is found before the ANT protocol. You may need to refresh the search to get the ANT ID to show up. BLE sensors typically include their name, while ANT sensors will just return an ID.

0 Former Member over 6 years ago

I have Quark Dzero and it works great with ANT.
What you need to do is disconnect (not remove) current power meter sensor and then add new sensor (will connect via ANT).

0 aweatherall over 6 years ago

This issue should be fixed in 5.0 if you wish to use the BLE pairing.

0 pelich29er over 6 years ago

Its fixed, since firmware 5.0 i don't have any problems