This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to choose ANT+ over Bluetooth with dual sensors

karlw2000 over 6 years ago

I have a Viiiva HRM and now a PowerTap P1 PM that both have Bluetooth and ANT+ wireless. I really want to use the ANT+ on both devices but the 1030 only defaults to Bluetooth. Since I haven't figured out how to turn off the Bluetooth I can't connect with ANT+. The P1 is especially important because I don't see left/right power balance when using Bluetooth.

Any ideas?

Top Replies

aweatherall over 6 years ago +2

The BLE signal is often detected by the Edge first when pairing. It can take a little longer for the ANT pairing to to show up.

If you are currently paired to the sensor over BLE. Go down to the sensor…

All Replies

0 essexboyracer over 3 years ago in reply to broncos74

That is correct, if you have a paired LR power meter, the right side talks to the left power meter then the left side then talks to the head unit. When pairing using ANT+ it should only be the left that is finds.