This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No TE and no training load

TomSawyer68 over 4 years ago

Hello

i have a marq expedition since one week.

i have no TE value using Trail runing or Run.

no VO2 max

and no recovery Time.

i did 7 activities and all my activities have training load 0 (run 20km...)

is this normal ?

thanks !

Top Replies

nmyeti over 4 years ago in reply to TomSawyer68 +1 verified

To make sure you understood meste7 to get vo2max you need to use the run activity 2x in a week. That said you should see some training load from any activity with heart rate even if you do not see training…
HermanB over 4 years ago in reply to acousticbiker +1

Simple answer is that what most people consider trail running includes almost non-stop changes in elevation, direction and intensity. The combination of these factors produce a data set that is very, very…

All Replies

0 meste7 over 4 years ago

On trail you will not get feedback on training load. Are you using external HR?

Sometimes it takes two weeks to start showing data

0 TomSawyer68 over 4 years ago in reply to meste7

Yes i’m using external HR.

after one week my training status is always down, and I run all days

0 meste7 over 4 years ago in reply to TomSawyer68

wait another week

0 TomSawyer68 over 4 years ago in reply to meste7

Ok meste7

+1 nmyeti over 4 years ago in reply to TomSawyer68

To make sure you understood meste7 to get vo2max you need to use the run activity 2x in a week. That said you should see some training load from any activity with heart rate even if you do not see training status.

One other thing to absolutely make sure is correct is your maxhr value. Without that set properly the system will not be remotely accurate on judging your training load and training effect.

0 TomSawyer68 over 4 years ago in reply to nmyeti

that’s the problem

no TRaining load for me.

Last week my load was 700 on my fenix 5x. This week 0 for all activities. Also 0 for 7 days activities.

i have set min and Max HR in GC...

0 TomSawyer68 over 4 years ago in reply to TomSawyer68

Drill no TE and no aerobic and anaerobic after 9 days.

this morning i have this

no screen about TE on Garmin Connect

Am I the only with this problem ?

0 TomSawyer68 over 4 years ago in reply to TomSawyer68

After 2 weeks still no TE...

i phoned Garmin, they don’t know...!

no idea ?

hard reset?

thanks

0 TomSawyer68 over 4 years ago in reply to TomSawyer68

I just did a hard reset

TE and recovery is working....

after syncing with GC app, it doesn’t work anymore. All my old data (vo2 max...) are upped in my new watch and TE doesn’t show anymore and training load is always 0.

I think Physio TrueUP is the culprit.....

am I the only one ?

thanks