This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Edge 1030 and Vector 2 will not calibrate

Former Member over 5 years ago

I have an Edge 1030 and Vector 2 Peds. While I can add the sensors to the Edge, they will not calibrate. Batteries have been replaced. I have removed the Vector 2 from my device, restarted the device and reconnected the Vector 2 with no change in results. Software on Edge updated again this morning.

Any ideas of what I can do?

0 Erik1503 over 5 years ago

Hello jayhawk.miller,

Mount Angle setting was successful?

Read out the left and right error codes on the edge 1030 @ Vector 2 (sensor connect) and post it here should be 0-0.

Greetings

Erik

0 Former Member over 5 years ago in reply to Erik1503

Mounting has not changed. They have worked in the past. I thought it might be a software update that messed with it.

I get no read out....just the calibration circle till it times out.

0 Erik1503 over 5 years ago

@ 1030 do an alternative sensor search -> search for any sensor instead of a Powermeter search.

Spin the crank a few times before sensor search.

All bluetooth devices except your 1030 should be shut down during sensor search.

Check the LED flashings at your Vector 2 -> They are error codes -> see your Vector 2 manual

Maybe a FW update of your Vector 2 with BT PC and Garmins "Vector Updater"