My tacx Flux smart is blinking red/green light. In the tacx smart training app it says: Warning 6.10, Mains voltage to low. Does anyone knows how to solve this problem?
There is no tacx support in brazil...
Hi. See below for the photos of my Tacx motherboard. There are at least two components blown or damaged. The R66 location component was a 3R3 surface mounted resistor 3.3 ohms I think. It was split in two. The other component is marked CGS 2W6 (Ohm)8J I think. It still measures 7.5 Ohms across the terminals.
hi, I checked with my PCB and it's not really the same but the damaged is the same , I think the components are identicals (for the 3R3 and the CGS 2W27ohm) . to be sure i changed too the mosfet just closed the resistance.
I ordered the components to digikey .
I changed 3 components :
1 resistance 3R3
1 resistance CGS 2W 27 ohm
1 mosfet STB12NK80ZT4
Be careful the resistance I selected is just a little more strengh 3W instead of 2W and a little bit big. check is you have enough space to solder it.
let me know is you have all understood !
this is the 3r3 i ordered at digikey
this the CGS 27ohms 3W (be carefull I only found a 3W instead of 2W ) the size is just a little more big , check if it's possible to put on your PCB.
I change the mosfet too , to prevent a problem
Your tacx model is not really the same than me but it's the same component which has crashed.
I hope it's will be the solution for you !