This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No data in Garmin with Bontrager duotrap S

Hi!,
I have attached the Bontrager duotrap S in my TREK EMONDA bike. When I move the crank the green light is flashing everytime the crank goes by. When I move the backwheel, I see the red light flashing every time the wheelmagnet goes by the duotrap.
Next I have paired the duotrap with the Garmin 1030. No additional configuration. But that's not needed I guess.
When I start riding there is no data on the Cadance fields (regular & avarage).
What went wrong?

0 ejdevries over 3 years ago

Did you pair the duotrap as speed sensor or as speed/cadence sensor?

0 5259017 over 3 years ago in reply to ejdevries

As a cadance sensor

0 2901093 over 3 years ago in reply to 5259017

I have the same trouble with same items... Edge 1030 with DuotrapS It's the same results with a garmin cadence...

0 2901093 over 3 years ago in reply to ejdevries

I did both with same results...An Update is usefull for Edge 1030...

0 BarryRoubaix over 3 years ago

Surely you need to pair this as a speed/cadence sensor combined and not as two separate sensors? As was the case with the older garmin speed/cadence sensor combo

0 5259017 over 3 years ago in reply to BarryRoubaix

Yes! This was the trick!

Thnx

0 1306321 over 3 years ago

I have the same problem. I have attached the duotrap s in my Emonda SL6, The Garmin pair normally the sensors, but there's no data for cadence and speed. The speed is read from gps. What's the solution ? I have removed and paired the sensor three times, but without results

0 5259017 over 3 years ago in reply to 1306321

Did you pair it as Cadence or Cadence/Speed sensors?