This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cycling Dynamics are not appearing

Hi all,

After switching from an Edge 1000 to an Edge 1030 the Cycling Dynamics data of my Vector 3 no longer appear in my Garmin Connect profile (web page), 
nor in the Garmin Connect App. 

The Edge has the V8.0 on it and also the Vector 3 pedals are up to date. 

But on the Edge itself the dynamics are displayed.

Any ideas how to fix this?

thanks
hela_ch

Top Replies

aweatherall over 4 years ago in reply to hela_ch +1 verified

If you are paired with BLE I would suggest just disabling it. Then doing a search. That way it will offer only the ANT connection. Pair with that and then go back and delete the BLE pairing.

All Replies

0 aweatherall over 4 years ago

Check under the sensor details for Vector 3 on the Edge that it is enabled,

0 hela_ch over 4 years ago in reply to aweatherall

Hi aweatherall,

seems this is the issue, but the relevant menu point "Cycling Dynamics" is not visible. I guess it's because of the wrong protocol, there is BLE instead of ANT+.

Do you know how to change this? When I remove and reconnect the Vector it's BLE again.

Thanks

+1 aweatherall over 4 years ago in reply to hela_ch

If you are paired with BLE I would suggest just disabling it. Then doing a search. That way it will offer only the ANT connection. Pair with that and then go back and delete the BLE pairing.