This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Issue charging

Roger1 6 months ago

Watch had updated to latest beta firmware, when I came to charge it this morning it seems to stop at 89 percent, has anyone else had this issue?

Fenix 8 pro 51mm

Thanks

0 trux 6 months ago

Possibly just the battery calibration voltage thresholds got lost during the update, which is not uncommon. Usually a hard reset (holding 30s the Light button), and going through two FULL charging cycles fixes the problem. Keep the watch on the charger an hour or two more after it stops incrementing the %, and then use it till the battery depletes. Then repeat it again.

0 Roger1 6 months ago in reply to trux

Cheers, i will try that.I did switch it on and off an hours ago and tried it again,it was ok .

0 indymtb 4 months ago

I have this exact problem. 90%. Tried shutting down by holding upper left button until it reset, but still caps at 90%.

0 stormtrooper505 4 months ago

One of the tradeoffs of being in the beta, you’re going to have issues