Fenix 6X Pro/Pro Solar - 2.32 Sensor Hub Beta Release

We have new Sensor Hub beta software ready for your upcoming adventures! Installation instructions can be found at the following link:

Fenix 6X Pro/Pro Solar - https://www8.garmin.com/support/download_details.jsp?id=15048

Note: Please allow for the update to propagate across all servers. There is no need to post that the link does not work. It will after a bit of patience.

Change Log Note:

Misc. WHR Improvements.

Top Replies

kachlicka over 4 years ago in reply to kachlicka +4

Nevermind, I am a dumbass and downloaded the file for 6S, not 6X installed!

All Replies

0 gaijin over 4 years ago

Easy install - thanks! Initial results look very promising with improved speed of results and continuity in Pulse Ox and Stress measurements.

0 Raul77 over 4 years ago

Against my better judgement I've installed this beta. Hope it doesn't have any bugs, so far so good.

0 kachlicka over 4 years ago

I load the file in the correct location via Android File Transfer app (I use a Mac), disconnect the 6X Pro, load it up (even restart) and.... nothing. What do I have to do to start the installation?

Current version of Sensor Hub is 2.10, sw 3.0

0 kachlicka over 4 years ago in reply to kachlicka

Nevermind, I am a dumbass and downloaded the file for 6S, not 6X installed!

0 SotirisAnagnostopoulos over 4 years ago

Yesterday evening, I installed the 2.25 sensor firmware and everything was good. Today in the morning, a message appeared on the screen, Software updated, installed (something like this) and the sensor hub was back on 2.10. Now I installed the 2.32. Let's test this....

0 tapuzzo over 4 years ago

(Classic bad science on my part, apologies in advance since I'm not sure which software fixed my problem.)

After installing both Sensor Hub 2.32 beta and Ant/BLE 4.18 beta, I am able to connect to my Garmin HRM-Run strap again. With the sensor hub 2.30 beta I lost the ability to connect to the HRM-Run strap (even after remove and attempt to pair it would never detect it.)

FWIW, Cadence/Speed Sensor 2 were working before and after the 2.30 beta.

0 tapuzzo over 4 years ago in reply to tapuzzo

oops, I meant sensor hub 2.25 beta was what broke my HRM-Run. I never got the 2.30 GA.

0 maglodilevente over 4 years ago

My watch has been updated with Garmin Express to Sensor HUB 2.30 and since then the WHR is fully meshed up.

I doing my recovery runs usally at 4:50-5:00 pace and 145-150 BPM. Today I've gone for the same workout with 5:10 AVG pace 163 AVG heartrate, with spikes to 180!!!, while the pace was constantly 5:10. I'm pretty sure my heart rate was about 150 BPM for the whole workout and with HRM RUN it works fine, so there must be something with the sensor hub update and the optical heart rate measuring.

Does anybody faced with the same issue? Should I install this beta to resolve it?

Thanks in advance!

0 harald.zingerle over 4 years ago

Still on 2.10, can't believe how bad HRM is on my 6x pro...

0 shanetkd over 4 years ago in reply to tapuzzo

Real long shot this one. My HRM-run strap stopped working after 2.25 still nothing when I went to 2.32. I changed the battery and it is working just fine now. I only put a new battery in it 6 months ago!