Fenix 6 Pro & Sapphire - 2.25 Sensor Hub Beta Release

We have new Sensor Hub beta software ready for your upcoming adventures! Installation instructions can be found at the following link:

Fenix 6 Pro/Sapphire - https://www8.garmin.com/support/download_details.jsp?id=15050

Note: Please allow for the update to propagate across all servers. There is no need to post that the link does not work. It will after a bit of patience.

Change Log Note:

Fixed a potential issue with WHR.

Top Replies

Hort_ over 4 years ago +2 suggested

I also installed in my Garmin Fenix 6 pro sapphire and same No Dada reading on OX graph, sensor is enable, the OX sensor as a update the LED is in red when measure de OX is a improve, with old version…
istv4n over 4 years ago +1 suggested

Both HR and PulseOX seem to be working with this update. Finally I can start enjoying my watch!

Largely disappointed in Garmin, the lack of transparency, communication and the overall way they handled…
C.sco over 4 years ago in reply to istv4n +1

istv4n said:
Largely disappointed in Garmin, the lack of transparency, communication and the overall way they handled this defective batch crisis

You are? I'm not. Note that not everyone's watches had this…

All Replies

0 troymosley over 4 years ago

Hello Odsweng,

I installed the updated software and unfortunately it didn’t not help with the HR sensor. It will work up until around 122-132 BPM, then it will steadily decline to the 90’s and then work its way back up and down.

0 Mes over 4 years ago

From my side, after applied 2.25 everything looks fine. I am after some tests for about 5 days now.

POX is now working good for 24h/day.

Also WHR works good, tested according to old sigma+hrm.

The measurement looks similar. Difference about 4HB/sec.

Sometimes 4hb less in peace, 4hb more during activity, but usualy measurements looks the same.

The accuracy is very impressive. Registered also max WHR 190.

More update leater.

0 Doug32571 over 4 years ago

System requirements

IBM-compatible PC running Windows 2000 or later operating system and an available USB port.

Do you have a fix for us Mac users?